Help Needed Asap

Post by **Mega** » Fri Aug 03, 2007 7:10 pm

Hi Guys need a little help. Just purchased a new rigg to build my self . I got Antec 900 Case, E6600 Processor - 2 Gig 6400 (800)mhz ram - OCZ Gamextreme PSU - Fatal1ty FP-IN9 Mother board - and a HD 2900XT card. My problem is the header connections in the case ( For reset switch - hhd light - Pwr Switch etc) are colour coded but dont know what colour is the + or - Colours are Blue & White - Purple & White - Black & White
(are the colours the + or is it the Whites
Thanks
Megazoneis1

Post by **Legthigh** » Fri Aug 03, 2007 7:15 pm

It shouldnt really matter mate tbh.

Post by **Mega** » Fri Aug 03, 2007 7:21 pm

It does state in the MB Manual that if connect wrong on the hhd light it just wont light up, but damage may occure if you connect the Pwr Switch incorrectly

Post by **Legthigh** » Fri Aug 03, 2007 7:25 pm

I've never caused any damage and never worry about the correct way round, but i'm very lucky

Post by **_RS_** » Fri Aug 03, 2007 9:29 pm

(positive)+ is always colour, white is always - (negative)

Post by **Mega** » Sun Aug 05, 2007 7:57 pm

Thanks ppl Im up and running. Just need to overclock it a bit so may be back on for help with that later

Post by **D3s3rt_F0x** » Tue Aug 07, 2007 1:56 pm

Ive been overclocking my new rig borrowed my mates after martket cooler for the day sat comfortably at the same speeds as a intel QX6850 which costs about Â£700 and still some headroom left in it I think. But for now im leaving it standard but I know theres always the room to push it that bit harder.

Post by **mcmav** » Thu Aug 09, 2007 1:59 pm

just cut the red wire k